Rear Outer Seat Belts, Wagon

Rear Outer Seat Belts, Wagon

• The following describes removing and installing on the right side of the vehicle. Removal and installation for the left-hand side is performed in the same manner.

Removing

- Remove the side cushion:

• with rear side airbags => [ Side Upholstery with Side Airbag ] Side Upholstery with Side Airbag.

• without rear side airbags => [ Side Upholstery without Side Airbag ] Side Upholstery without Side Airbag.

- Remove luggage compartment side trim. Refer to => [ Luggage Compartment Side Trim, Wagon ] Luggage Compartment Side Trim, Wagon

- Remove the bolt - 1 - (40 Nm) and remove seat belt guide - 2 - from body.

Vehicles with belt tensioner

- Disconnect the battery.


Electrostatic discharges can lead to unintended deployment of the airbag. Therefore, mechanic must electrostatic discharge him-/herself before disconnecting harness connector. This is done, for example, by briefly grasping the chassis or door striker.

- Disconnect wiring harness connector - 7 -.

All vehicles

- Remove bolt - 6 - (40 Nm) and remove automatic belt retractors - 5 - from body.

- To remove the belt guide - 3 -, remove the bolts - 4 - (6 Nm) and remove the belt guide upward.






Installing

- Install in reverse order of removal.