Steering Column Combination Switch (E595), Valeo

Steering Column Combination Switch (E595), Valeo


Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.


• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Follow the safety precautions when working on the airbag.


Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronic systems control module (J527). Refer to=> [ Steering Column Electronic Systems Control Module (J527) ] Steering Column Electronic Systems Control Module (J527).

- Open the tabs - arrows - and remove the steering column combination switch (E595) from the steering column switch base carrier.






Installation

- Slide the steering column combination switch into the guides on the steering column switch base carrier until it latches secure.

- Connect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Further installation is done in reverse order of removal.