Replacing

Automatic High Beam Control Module (J844), Removing and Installing

The procedure for "replacing the automatic high beam control module" includes the following steps:

• If a new automatic high beam control module (J844) (new interior rearview mirror) is installed in the vehicle, then it must be coded.

• Then the automatic high beam control module (J844) must be adapted.

The procedure to "replace the automatic high beam control module" can only be performed with the -> Vehicle diagnostic tester in the "guided fault finding" function.

Procedure

- -> Vehicle diagnostic tester Connecting.

- Select Guided Fault Finding.

- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:

• Body

• Electrical Equipment

• 01 - On Board Diagnostic (OBD) capable systems

• 20 - Headlamp Assistant J844

• High beam assistant, functions

• Replace control module