New Control Module, Installing

New Control Module, Installing


Excessive shaking (e.g. dropping, impact) may destroy the control module. Control module must then no longer be used.

• Surface must be cleaned before assembling.

- Slide all sealing rings - A - slightly over the valve dome.





- Place control module without canting it onto hydraulic unit.

Sealing rings are then brought into their end position.

- Install the hydraulic unit and control module with the new inner Torx bolts diagonally according to the tightening specification.

• A new control module may be installed a max. of two times to a used hydraulic unit, to ensure that the elastic gasket seals sufficiently.

• A control module which was once in driving operation must not be installed a second time.