Ignition Switch

Ignition Switch


Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the trim from the steering column.

- Disconnect the connector - 2 - from the ignition switch - 1 -.






- Unlock the ignition switch with a small screwdriver - arrows -.

- Remove the ignition switch - 1 - from the steering lock housing.

Installation

- Install the ignition switch in the steering lock housing until it audibly latches.

- Insert ignition key into lock cylinder and turn into position "Drive".






• Key must be located in "Drive" position.

Key positions of lock cylinder:

1. Position Off

2. Position Run

3. Position Start


- Install the components in reverse order of removal.