EGR Temperature Sensor G98

EGR Temperature Sensor G98

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm Dia. (3094)

• Torque Wrench (5-50 Nm) (V.A.G 1331)

• Drip Tray for VAS 6100 (VAS 6208)

• Hose Clip Pliers (VAS 6362)

• 14 mm Socket (T10401)

Requirements

• The ignition is off.

• The engine must be cold.

Procedure

- Remove the noise insulation.

- Drain the coolant. Refer to => [ Draining and Filling ] Draining and Filling.

• The coolant hoses indicated must be removed and moved to the side to perform assembly work on the Exhaust Gas Recirculation (EGR) temperature sensor.

- Disconnect the coolant hoses from both connections - arrows A and D -.






- Lay aside both coolant hoses - arrows B and C - as illustrated.

- Remove the engine cover. Refer to => [ Engine Cover ] Engine Cover.


Electronic components could be destroyed when the battery is disconnected:

• Follow the required steps when disconnecting the battery.

- With the ignition turned off, disconnect the ground cable - arrow - from the battery.






- Remove the air filter housing. Refer to => [ Air Filter Housing ] Air Filter Housing.

- Remove the battery, the battery tray bolts - arrows - and tray.






- Disconnect the connector from the EGR temperature sensor - arrow A - and guide the wire out.






• Note the installation location of the lines and heat shield.

The illustration shows the EGR temperature sensor as seen from the engine compartment looking out from the transmission side - arrow - below the brake master cylinder.






- Carefully guide the 14 mm socket (T10401) with an extension onto the EGR temperature sensor.






- Make sure the wire from the EGR temperature sensor is guided into the groove on the 14 mm socket (T10401) - arrow A -.






- Loosen the EGR temperature sensor and remove it.

Installing

- Install in the reverse order of removal. When doing this note the following:

• EGR temperature sensor tightening specification: 20 Nm

• Cut off the gasket and replace if it is damaged or leaks

• Maintain the tightening specification.


Install the heat shield mats in their original locations.

Make sure the entire connection is seated securely.

Always replace self-locking nuts, seals, gaskets and clamps.

Hoses are secured with spring type clamps.

hose clip pliers (VAS 6362) or (VAS 6340) are recommended for installing spring type clamps.