Compression Check: Testing and Inspection

Compression, Checking

• The compression can also be checked using a vehicle diagnostic tester such as the vehicle diagnosis, testing and information system (VAS 5051 B).

Special tools, testers and auxiliary items required

• Compression Tester (V.A.G 1763) with Adapter (V.A.G. 1763/8)

Test Conditions

• Engine oil temperature must be at least 30 °C (86 °F).

• The battery voltage must be at least 12.7 volts.

• All electrical consumers such as, for example, lights and rear window defogger, must be turned off.

Test Sequence

- Remove the glow plug from the corresponding cylinder. Refer to => [ Glow Plugs ] Description and Operation.

- Install the adapter (V.A.G 1763/8) in place of the glow plug.

- Check the compression pressure using the compression tester (V.A.G 1763).

• Using the tester, refer to the tester operating instructions.

- Operate the starter until the tester show there is no further increase in pressure.

Compression Pressure

• New: 25.0 to 31.0 bar

• Wear limit: 19.0 bar

• Permissible difference between all cylinders: maximum 5.0 bar

- Install the glow plug to the corresponding cylinder. Refer to => [ Glow Plugs ] Description and Operation.

• By disconnecting the connectors, Diagnostic Trouble Codes (DTCs) are stored to memory. After the test, check the fault memory and erase, if necessary.

- Check the DTC memory of the Engine Control Module (ECM) and erase all of the DTC entries. Refer to the vehicle diagnostic tester.