Timing Component Alignment Marks: Locations

Toothed Belt Timing Component Alignment Marks


- Rotate the engine to Top Dead Center (TDC) and secure the crankshaft toothed belt gear using the crankshaft stop (T10050). Push the crankshaft stop from the front side of the toothed belt gear into the teeth. The toothed gear must be in the "12 o'clock" position.






• The marks on the crankshaft toothed belt gear - 2 - and the crankshaft stop (T10050) - 1 - must align. The pin on the crankshaft stop (T10050) must engage in the hole on the sealing flange.

- Mark the rotational direction of the toothed belt.