Rear Wheel Housing Liner Assembly Overview

Rear Wheel Housing Liner Assembly Overview

• The following describes removing and installing the left rear wheel housing liner. Removing and installing the right rear wheel housing liner is identical.

• Due to equipment variations, small deviations must be considered during removal and installation.

• The illustration shows a left fender. The right fender is identical.






1 Rear wheel housing liner

• Material - PP/EPDM

• Removing, refer to => [ Rear Wheel Housing Liner ] Rear Wheel Housing Liner

2 Bolt

• Quantity: 9

• Tightening specification: 2 Nm

3 Expanding nut

• Quantity: 3

4 Expanding nut

• Gas-tight


Check the gas-tight expanding nuts for damage and replace if necessary.

The expanding nuts seal off the passenger compartment from exhaust gas and must always be replaced if they are damaged.