Plastic Relay Lever

Plastic Relay Lever

From 03.07 - Plastic Relay Lever





• To remove the relay lever, it is necessary to remove the cable retainer from the selector cable.

This prevents damage to the selector cable.






- Pull the securing mechanism all the way forward in direction of - arrow 1 - and then unlock to the left in direction of - arrow 2 -.

- Push the relay lever forward (direction of - arrow 3 -).

Relay Lever with Tab - arrow 1 - (see previous illustration)

- Push the tab - arrow 1 - (see previous illustration) all the way down and remove the relay lever and cable retainer. Move the relay lever in the operating direction at the same time.

Relay Lever with Clip - arrow 1 -





- Remove the clip - arrow 1 - and remove the relay lever along with the cable retainer.

Continuation for All

The cable retainer must be behind the catch - arrow 2 -.

• The cable retainer may only be removed with the relay lever removed. Refer to => [ Removing the Selector Cable Retainer
from the Plastic Relay Lever. ]

• To install, grease the mounting points and contact surfaces with using grease (G 000 450 02).

- Press the cable retainer on the relay lever. Refer to => [ Installing the Cable Retainer ]

- Insert the relay lever together with the cable retainer as far as the stop.

Relay Lever with Tab - arrow 1 - (see previous illustration).

• The tab - arrow 1 - secures the relay lever (see previous illustration).

• Make sure it engages securely.

• The cable retainer must be behind the tab - arrow 2 - (see previous illustration).

Relay Lever with Clip - arrow 1 - (see previous illustration).

• The clip - arrow 1 - secures the relay lever.

• Make sure the clips locks securely.

• The cable retainer must be behind the catch - arrow 2 -.

Removing the Selector Cable Retainer from the Plastic Relay Lever.





• The relay lever is removed

- Insert a screwdriver - A - between the bushing - B - and the relay lever.

Installing the Cable Retainer





• The relay lever is removed

• The cable retainer may only be installed at the bushing - arrow -.

• The cable retainer must move freely on the relay lever.

• It must be behind the tab - arrow 2 -, refer to => [ From 03.07 - Plastic Relay Lever ]