Input Shaft Overview

Input Shaft Overview

• Install all input shaft bearings with transmission fluid.






1 Locking Ring

• For the grooved ball bearing/input shaft - item 6 - => [ (Item 6) Grooved Ball Bearing ]

• Removing and installing, refer to => [ Transmission, without a Sealing Cap Circlip for the Input Shaft ] Transmission, Without a Sealing Cap Circlip For the Input Shaft

2 Washer

• Outer circumference = 78.6 mm

• Only insert with the changed transmission housing (from transmission production date 4.10.06 through approximately 1.20.08). Refer to => [ Grooved Ball Bearing Changes ] Input Shaft.

• Refer to the Parts Catalog

3 Transmission Housing

• Adapted in the grooved ball bearing seat area - item 6 - => [ (Item 6) Grooved Ball Bearing ] and washers - item 2 - => [ (Item 2) Washer ] and - item 4 - => [ (Item 4) Washer ] from transmission build date 4.10.06 through approximately 1.20.08.

• Flattened areas on the grooved ball bearing and bearing seat approximately from transmission build date 1.21.08, refer to => [ Grooved Ball Bearing Changes ] Input Shaft

• Refer to the Parts Catalog

4 Washer

• Outer circumference = 85 mm

• Only insert with the changed transmission housing (from transmission production date 4.10.06 through approximately 1.20.08).

• Refer to the Parts Catalog

5 Locking Ring

• Select when replacing the grooved ball bearing - item 6 - => [ (Item 6) Grooved Ball Bearing ] and the input shaft - item 8 - => [ (Item 8) Input Shaft ]. Refer to => [ Determining the Grooved Ball Bearing
Locking Ring on the Input Shaft ] Input Shaft

6 Grooved Ball Bearing

• Always replace

• Removing, refer to => [ Removing the Grooved Ball Bearing ] Input Shaft

• Installed position, refer to => [ Grooved Ball Bearing Installed Position ] Input Shaft

• Installing; refer to => [ Installing the Grooved Ball Bearing ] Input Shaft

• Flattened areas on grooved ball bearing and bearing seat approximately from transmission build date 1.21.08, refer to => [ Flattened areas on the grooved ball
bearing and bearing seat in the transmission housing approximately from transmission build
date 2.21.08. ] Input Shaft

7 5th Gear

• Offered together with the input shaft as a replacement part

• Removing, refer to => [ Removing the 5th Gear ] Input Shaft

• Installed position: The surrounding groove - arrow - points toward grooved ball bearing - item 6 - => [ (Item 6) Grooved Ball Bearing ]

8 Input Shaft

• With 3rd/4th and 6th gear

9 Cylindrical Roller Bearing

• With locking ring

• Removing, refer to => [ Removing the Cylindrical Roller Bearing
from the Clutch Housing ] Input Shaft

• Installing, refer to => [ Pressing Cylindrical Roller Bearing
Into Clutch Housing. ] Input Shaft

• Installed position: The locking ring inside the bearing faces the input shaft

10 Clutch Housing