Line and Bleeder on the Slave Cylinder

Line and Bleeder on the Slave Cylinder

Special tools, testers and auxiliary items required

• Torque Wrench 5-50 Nm (V.A.G 1331)

Removing and Installing the line - 4 - on the Bleeder - 1 -





- Open the locking clamp - 2 - with a screwdriver or a pointed tool and remove the pipe - 4 - from the bleeder - 1 -.

- Push the line - 4 - and O-ring - 3 - into the bleeder valve connection - 1 - until the locking clamp - 2 - engages audibly.

- Pull on the line to make sure it is secure.

Removing and Installing the Bleeder - 4 - from the Slave Cylinder





- To remove, open the clip - 2 - with a screwdriver or a pointed tool and remove bleeder - 4 - from slave cylinder - 1 -.

- Check the O-ring - 3 - on the clutch slave cylinder. Press in the bleeder at the slave cylinder connector until the locking clamp - 2 - engages audibly.

- To check, pull on the bleeder.

- Bleed the clutch mechanism. Refer to => [ Clutch System, Bleeding ] Procedures.