Relay Carrier In Left Instrument Panel

Relay Carrier In Left Instrument Panel


Follow the procedure in the Repair Information when disconnecting and connecting the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the trim from the footwell on the driver side.

- Remove relays - arrows - from relay carrier.






• The number of relays and fuses is dependent on vehicle equipment.

- Clip retaining tabs in - direction of arrow - outward and then press connectors - 1 - through relay carrier.






- Disengage bracket - arrow A - and pull off bracket with fuse from relay carrier in - direction of arrow B -.






- Disengage catches in - direction of arrow - and pull thermo-fuses - 1 - out of mounts.






- Release retaining tab - 1 - in - direction of arrow A - and pull off mount from relay carrier in - direction of arrow C -.






- Release retaining tab - 2 - in - direction of arrow B - and pull off mount from relay carrier in - direction of arrow C -.

- Release retainer - 1 - for relay panel in direction of - arrow - and remove relay panel.






Installation

Install in reverse order of removal, noting the following:

- First clip connector (for relay), holder (for fuse) and mounts (for thermo-fuses) into relay carrier.

- Place relay carrier - 2 - into guide - 1 - and then engage relay carrier.