Alarm Horn: Service and Repair

Alarm Horn

Special tools, testers and auxiliary items required

• Drill (VAS 5134)

• To remove the alarm horn, anti-theft alarm system must be deactivated. Refer to => [ Anti-Theft Alarm System, Activating and Deactivating ] Anti-Theft Alarm System, Activating and Deactivating.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the right front wheel housing liner..

- Using the (VAS 5134) , drill off the heads on both blind rivets - arrows -.






- Disengage harness connector - 1 - through opening in housing - 2 - using a small screwdriver and remove Alarm Horn (H12) - 3 - out of wheel housing.






- Remove any remaining material from the rivet - arrows - from the holes in the body.






Installation

• Remove any metal chips and any remaining material from the blind rivets.

- Apply corrosion protection.

- Connect harness connector to Alarm Horn.

• For reasons of clarity, the Alarm Horn (H12) is not depicted in the following illustrations and thus the connector is not connected.

- Guide clip - 2 - for Alarm Horn into body cutout - 1 -.






- Attach the alarm horn using new blind rivets.

- Install the right front wheel housing liner..