Left Footwell Lamp (W9) Bulb

Left Footwell Lamp (W9) Bulb

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned, using commercially available adhesive tape.

• Removal and installation for both footwell lights is performed in the same way and is only described for one light.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the left footwell lamp. Refer to=> [ Left Footwell Lamp (W9) ] Left Footwell Lamp (W9).

- Disengage retaining tabs - 1 - and remove heat shield - 2 - from diffusion lens of light.






- Carefully pry bulb from socket.






- Glass base bulb: 12V, 5W

Installation

Install in reverse order of removal, noting the following:

- Tighten the screw on the bracket for the footwell lamp and diagnostic socket to 1.5 Nm.