Roof Edge Spoiler Installation Information

Roof Edge Spoiler Installation Information

The surfaces of the components to be primed must be free of dirt.

- Remove adhesive residue using (D 002 000 10).

- Saturate a cloth with (LSE 020 100 A3).

- Always wipe application area for adhesive bead twice using saturated cloth and allow to air dry.

- Now apply glass/primer uniformly in one stroke using (D 009 500 25).

• Drying time is approximately 10 minutes

- Adhesive material must be applied to the primed surfaces of the component.


Components must be installed within 10 minutes, otherwise bonding properties of adhesive will be impaired.

• Keep gap dimensions as narrow as possible, approximately 1 mm.

• Secure components using adhesive tape during the minimum curing time.