Washer Fluid Level Switch: Service and Repair

Windshield Washer Fluid Level Sensor (G33)

The windshield washer fluid level sensor is located in front of the right front edge and is inserted in the tank for the windshield/headlamp washer system.

• Depending on the equipment, the installation location of the windshield washer fluid level sensor may differ slightly from the figures. Removal is identical.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the front bumper cover.

- Release and disconnect the harness connector - 1 - on the windshield washer fluid level sensor (G33).






- Pull the windshield washer fluid level sensor - 2 - out of its rubber seal.

- Catch any draining fluid in a suitable container.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Bleed the headlamp washer system after conclusion of the assembly steps. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.