Adjusting Angle

Adjusting Angle






• The rear lid is adjusted.

- Remove side trim.

- Loosen threaded pin nut - 3 - to adjust angle.

- Adjust threaded pins with Side Window Installation Tool (V.A.G 1739).

- Tighten the locking nut - 3 -, tightening specification: 10 Nm.

The window regulator must not be tensioned.

- Loosen nuts - 2 - and adjust threaded pins with Side Window Installation Tool (V.A.G 1739) until threaded pins lightly contact window regulator.

- Tighten nuts - 2 -. Tightening specification: 10 Nm.

- Perform a function check and check adjustment with roof open and closed.

- Check adjustment dimension of side window with roof closed. Refer to => [ Side Window Adjustment Dimensions ] Side Window Adjustment Dimensions.