Steering Gear Assembly Overview, Generation 2, through MY 2008

Steering Gear Assembly Overview, Generation 2, through MY 2008

• The generation 2 steering gear is no longer available as a replacement part.

• Install a generation 3 steering gear if replacing a steering gear.

• In addition to this, the electrical wiring set from the E-box to the steering gear must be changed. It will be included with the new steering gear. Allocation, refer to the Electronic Parts Catalog (ETKA).

• The electrical wiring set is delivered complete together with the wiring for the service interval display.

• If the vehicle does not have a service interval display, then the 3-pin connector, not being used, must be sealed off with a flat terminal housing with contact seal (1J0 973 803). Allocation, refer to the Electronic Parts Catalog (ETKA).






1 Universal Joint

2 Bolt

• 30 Nm

• Always replace if removed.

3 Electrical Wiring

4 Power Steering Gear

• With Power Steering Control Module (J500).

• With Electro-mechanical Power Steering Motor (V187).

• With Steering Torque Sensor (G269).

• Can be checked in Guided Fault Finding with the Vehicle Diagnostic Tester.

• Removing and installing, refer to => [ Steering Gear, Generation 2, through MY 2008 ] Steering Gear, Generation 2, through MY 2008.

• See notes.

5 Wheel Bearing Housing

6 Nut

• M12 x 1.5

• 20 Nm + 90° turn

• Self-locking

• Always replace if removed.

7 Subframe with Brackets

8 Bolt

• 50 Nm + 90° turn

• Always replace the clamp for the steering gear.

• Always replace if removed.

9 Shield

10 Bolt

• 6 Nm

• Self-tapping