With Freewheel, Valeo

With Freewheel, Valeo

Special tools, testers and auxiliary items required

• Multi-tooth Adapter (VAS 3400)

• Torque Wrench (V.A.G 1332)

• TORX Screwdriver Insert (V.A.G 1603/1)

Removal

- Remove the generator. Refer to=> [ Generator ] Generator.

- Clamp the generator in a vise at the mounting points.

- Remove the protective cap from the ribbed belt pulley with freewheel.

- Insert the (VAS 3400) into the ribbed belt pulley with freewheel of the generator using a box wrench (17 mm).

- Insert the (V.A.G 1603/1) into the generator shaft.






- Turn the threaded connection to the right while counter-holding it with the box wrench.

- Hold the ribbed belt pulley with freewheel in place by hand and turn it at the generator input shaft until the ribbed belt pulley can be removed with freewheel.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Next, screw the ribbed belt pulley with freewheel by hand onto the generator input shaft to the stop.

The (V.A.G 1332) must be reconfigured for installing the ribbed belt pulley with freewheel as follows:

- Release the insert - 1 - and remove it from the handle part - 2 -.






- Turn the handle part - 2 - of the torque wrench 180° and reinsert the socket.

- Set the rotation direction of the torque wrench socket to "left".

- Insert the (V.A.G 1603/1) into the generator shaft.






- Counter-hold the (VAS 3400) with the box wrench (17 mm).

- Use the (V.A.G 1332) to tighten the ribbed belt pulley with freewheel by turning the generator input shaft to the left.

- Tighten the threaded connections to 80 Nm.