Footwell Lamp

Footwell Lamp

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

• Left footwell lamp (W9) with left front footwell illumination bulb (L151)

• Right footwell lamp (W10) with right front footwell illumination bulb (L152)

• Left rear footwell lamp (W45) with left rear footwell illumination bulb (L106)

• Right rear footwell lamp (W46) with right rear footwell illumination bulb (L107)

• The front footwell lamps are installed in the trims under the instrument panel.

• The rear footwell lamps are installed under the front seats.

• The footwell lamps can be checked via the output diagnostic test mode of the Vehicle electrical system control module (J519).

• When removing and installing components in a visible area (switches, covers, trims, etc.), use commercially available adhesive tape to mask off the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned.

• Removing and installation is the same for all footwell lights and is described here for only one light.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Use the (VAS 3409) or a screwdriver to pry the footwell lamp out of the trim.






- Release and disconnect the harness connector - arrow - and remove the footwell lamp.






Installation

Installation is performed in the reverse order of removal.