Brake Testing with a Standard One-Axle Dynamometer, AWD,

Brake Testing with a Standard One-Axle Dynamometer, AWD,

• The testing takes place on a test stand.

• During testing, manual transmission vehicles must in idle and automatic transmission vehicles must be in N.

• Always observe the test stand manufacturer instructions.

• The brake systems do not work when the ignition is off.

- Drive the vehicle forward onto the rollers.

- Turn off the engine and wait 2 seconds.

- Perform the braking test.

- Start the engine and wait approximately 5 seconds until there is enough vacuum.

- Drive the vehicle forward until the rear wheel are standing on the rollers.

- Turn off the engine and wait 2 seconds.

- Perform the braking test for the rear brakes.

- Start the engine and wait approximately 5 seconds until there is enough vacuum.