Brake Caliper Overview, CI 38 and CII 38

Brake Caliper Overview, CI 38 and CII 38






1 - Brake Caliper with Parking Brake Cable Lever

• Replace brake caliper if leaking at parking brake cable lever.

• Pre-bleed brake caliper after repairing, refer to => [ Brake Caliper, Pre-Bleeding ] Brake Caliper, Pre-Bleeding.

2 - Dust Cap

3 - Bleeder Valve

• 10 Nm

• Apply a thin coat of assembly paste G 052 150 A2 to the threads before screwing in.

4 - Self-Locking Bolt

• 35 Nm

• Replace

• When loosening and tightening, counter-hold at guide pin.

5 - Guide Pins

• Grease before pulling on protective cap.

6 - Cap

• Install on brake carrier and guide pin.

7 - Brake Carrier with Guide Pins and Cap

• CII 38 brake illustration.

• Supplied as an assembled replacement part with sufficient grease on guide pins.

• If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins.

8 - Cap

• Pull onto piston with outer sealing lip.

• Removing and Installing, refer to => [ Brake Caliper Piston ] Brake Caliper Piston.

9 - Piston with Automatic Adjustment

• Removing and Installing, refer to => [ Brake Caliper Piston ] Brake Caliper Piston.

• Apply thin coat of assembly paste G 052 150 A2 to piston before inserting.

10 - Seal

• Removing and Installing, refer to => [ Brake Caliper Piston ] Brake Caliper Piston.