General Information

General Information

If a bumper cover is repaired or a new bumper cover is installed, the parallel parking assistance sensor brackets must be properly aligned and glued to the inside of the bumper cover. Before bonding, the sensor brackets in the front bumper cover and the sensors must be painted separately to match the color of the bumper cover. When painting the sensor brackets and the sensors, certain conditions must be met in order to ensure proper sensor and parking aid system functioning. Preparation of the adhesive contact surfaces and the adhesive process are to be performed while observing the following process steps. Use the corresponding repair kit. Refer to Electronic Parts Catalog (ETKA).

Process steps:

• Painting of the parallel parking assistance sensors, refer to=> [ Parallel Parking Assistance Sensor, Painting ] Parallel Parking Assistance Sensor, Painting.

• Painting of the parallel parking assistance sensor brackets in the front bumper cover, refer to=> [ Painting Parallel Parking Assistance Sensor Brackets In Front Bumper Cover ] Painting Parallel Parking Assistance Sensor Brackets In Front Bumper Cover.

• Allocation of the parallel parking assistance sensor brackets to the installation location in the bumper cover, refer to=> [ Allocating Parallel Parking Assistance Sensor Brackets To Installation Location ] Allocating Parallel Parking Assistance Sensor Brackets To Installation Location.

• Glue the parallel parking assistance sensor bracket into the bumper cover, refer to=> [ Gluing Parallel Parking Assistance Sensor Bracket Into Bumper Cover ] Gluing Parallel Parking Assistance Sensor Bracket Into Bumper Cover.

• Pay attention to the installation instructions in the repair kit.