Steering Column Switch Base Carrier, Valeo

Steering Column Switch Base Carrier, Valeo

Special tools, testers and auxiliary items required

• Angled Hand Drill

• Torque Wrench (V.A.G 1410)

Follow the specified sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

Removal

• The shear bolts - 1 - on the Electronic steering column lock control module (J764) must be drilled out in order to remove the steering column switch base carrier - 2 -. New shear bolts will be needed later for installing. Refer to Electronic Parts Catalog (ETKA).






• Before drilling out shear bolts, always ensure all components secured to base carrier are removed beforehand.

• By drilling out, drill shavings can reach the neighboring components, which can lead to damage and / or malfunctions!

• When removing the steering column switch components, observe the specified sequence. Refer to=> [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

When disconnecting and connecting the battery, always perform the work procedure as described in the repair information. Refer to=> [ Battery, Disconnecting and Connecting ] Service and Repair.

Removal

- Disconnect the battery. Refer to=> [ Battery, Disconnecting and Connecting ] Service and Repair.

- Remove all components attached to the base carrier in the specified sequence. Refer to=> [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

Once all components secured to the base carrier have been removed, the base carrier can be removed:

- Drill out the shear bolts - 1 - of the Electronic steering column lock control module (J764) - 3 -.






• Bolts M8 - 1 -, core hole diameter 6.8 mm.

- Release and disconnect the harness connector on the back of the electronic steering column lock control module - 3 - and remove the electronic steering column lock control module together with the steering column switch base carrier - 2 - from the steering column.

- Release the latching mechanisms - arrows - on the steering column switch base carrier and remove the base carrier - 1 - from the electronic steering column lock control module - 2 -.






Installation

- Install the steering column switch base carrier - 1 - on the electronic steering column lock control module (J764) - 2 - until it locks in place.






- Slide the steering column combination switch (E595) onto the steering column switch base carrier until it locks in place.

- Slide the pre-assembled unit of the electronic steering column lock control module, the steering column switch base carrier and the steering column combination switch straight onto the steering column all the way to the stop and align with respect to the threaded holes.

- Secure the electronic steering column lock control module to the steering column with new shear bolts - 1 -.






- Tighten the new shear bolts - 1 - until the bolt heads shear off.

- Install all components accordingly in the reverse order.

• A new electronic steering column lock control module must be coded after installation. Refer to=> [ Electronic Steering Column Lock Control Module (J764) KESSY, Coding ] Electronic Steering Column Lock Control Module (J764) KESSY, Coding.