Fuel Filler Door Unit

Fuel Filler Door Unit

Removing






- Remove the tank cap.

- Remove the bolt - 2 -.

- Pull tank flap unit - 1 - with drain hose - 3 - toward rear out of retainers and swing tank flap unit - 1 - out of side panel.

- Fold back boot from tank filler neck.

- Unclip assembly piece - 4 - from side panel and pull off assembly piece from release rod - 5 -.

Installation






• Assembly piece - 4 - is clipped in.

- Insert drain hose - 3 - through opening in tank flap unit and pull drain hose through until it stops.

- Guide drain hose into side panel.

- Slide tank flap unit - 1 - with hinge side first into side panel.

- Pivot the fuel filler door unit completely into the side panel. Make sure the top and bottom of the fuel filler door unit engages correctly in the side panel.

- Pull rubber piece over tank filler neck and tighten bolt - 2 -.