Shift Lever and Housing, through 10.06

Shift Lever and Housing, through 10.06

• Lubricate the bearing areas and the sliding surfaces.

• Grease allocation, refer to the Parts Catalog.






1 Lock Washer

• Removing and installing, refer to => [ Lock Washer, Removing and Installing ] Shift Lever and Housing, from 11.06.

2 Bushing

3 Pressure Spring

4 Bushing

5 TORX(R) Bolt

• 5 Nm

6 Cover

7 Insulation

8 Insulation

9 Bearing Shell

10 Shift Lever Guide

11 Washer

12 Gasket

• Between the shift housing and the underbody.

• With self adhesive.

• Affix to the shift housing.

13 Shift Lever

14 Shift Housing

15 Bushing

16 Pin

17 Bushing

18 Pressure Spring

• Installing, refer to => [ Installing the Pressure Spring ].

19 Selector Bracket

20 TORX(R) Bolt

• 5 Nm

21 Gasket

• Always replace.

22 Base Plate

• Bend the tabs down in order to remove.

• Always replace.

• Attaching, refer to => [ Attaching the Base Plate to the Shift Housing ] Selector Mechanism.

23 Selector Cable

• To the selector bracket.

• Disconnecting from the selector bracket.

24 Shift Cable

• Disconnecting from the shift lever guide.

25 Lock Washer

• Always replace.

26 Nut

• M6: 8 Nm

• M8: 25 Nm

• Quantity: 4

27 Bushing

• Fits in one position only.

28 Lock Washer

• Always replace.

Selector and Shift Cables, Disconnecting





- Remove the lock washers from the shift cable - A - and the selector cable - B -.

Lift the tab with a screwdriver - arrow 1 - and remove the lock washer - arrow 2 -.

- Remove the shift cable - A - from the shift lever guide.

- Remove the selector cable - B - from the selector bracket.

Installing the Pressure Spring





- Install the pressure spring so that the leg - A - contacts the upper part of the pin - arrow -.

- Pull the leg - B - downward so that it reaches the bottom of the pin - arrow -.