Left Flange Shaft and Seal

Left Flange Shaft and Seal

Special tools, testers and auxiliary items required

• Slide Hammer-Complete Set (VW 771)

• Additional Part for VW 771 (VW 771/37)

• Thrust Piece (3305)

• Torque Wrench (5-50 Nm) (V.A.G 1331)

• Torque Wrench (40-200 Nm) (V.A.G 1332)

• Sealing Grease for Seal (G 052 128 A1)

Removing

- Remove the left wheel.

- Remove the noise insulation. Refer to one of the following:

GTI (2006-2009), Golf/GTI (from 2010) and Passat

Eos

CC

- Remove the lower part of the left front wheel housing liner..

- Remove left drive axle.

- Place a drip tray under the transmission.

- Remove the flange shaft bolt, by installing two bolts into the flange and counter holding the flange shaft with a pry bar.






- Remove the flange shaft and the pressure spring.

- Remove the flange shaft seal.






Installing

- Install the seal until seated and without tilting it using the thrust piece (3305).






- Fill the space between the sealing and dusts lip half way with sealing grease for seal (G 052 128 A1).

- Install the flange shaft.






- Secure the flange shaft with the bolt and tighten it to specification, see - item 12 - in the => [ Differential ] Service and Repair.

- Install the left drive axle.

- Install the lower section of the left front wheel housing liner..

- Install the wheel.

- Check the transmission fluid level. Refer to => [ Transmission Fluid, Checking ] Service and Repair.

- Install the noise insulation. Refer to one of the following:

GTI (2006-2009), Golf/GTI (from 2010) and Passat

Eos

CC