Input Shaft Seal

Input Shaft Seal

Special tools, testers and auxiliary items required

• Extractor Lever (T20143/1)

• Thrust Piece (T40008)

• Sealing Grease for Seal (G 052 128 A1)

Requirement

• The transmission is removed.

Removing

- Remove the clutch slave cylinder and the release bearing. Refer to => [ Slave Cylinder with Release Bearing ] Service and Repair.

- Pry out the input shaft seal using the extractor lever (T20143/1).






• Be careful not to damage the contact surface for the seal on the input shaft.

Installing

- Fill the space between the sealing and dust lips - arrow - halfway with sealing grease for seal (G 052 128 A1).






- Lightly coat the outer circumference of the seal with gear oil.

- Drive in the seal using the thrust piece (T40008) until it is flush.






- Install the clutch slave cylinder and release bearing. Refer to => [ Slave Cylinder with Release Bearing ] Service and Repair.

• Install the transmission.