Selector Mechanism Overview, from 03.09

Selector Mechanism Overview, from 03.09

Move the selector lever into the "P" position and set the parking brake before working with the engine running.






1 Selector Handle with Cover

• Do not remove the handle unnecessarily. For emergency release, only cover must be removed. Refer to => [ Selector Lever, Manual Release ] Procedures.

• Button on the side: Pull the button out of the handle just far enough until there is a small gap between the handle and the button. The button will lock in this position once it is released. Prevent the button from being pressed in using a cable tie or wire.

• Button in the front: The button is locked in its installed position when the handle is removed.

• Removing and installing, refer to => [ Selector Lever Handle ] Selector Lever Handle.

2 Selector Lever and Selector Mechanism with Selector Lever Cable

• With the shift lock solenoid.

• Do not grease cable.

• Removing and installing, refer to the following:

=> [ Selector Mechanism with Housing, from 03.09 ] Selector Mechanism with Housing, from 03.09.

=> [ Selector Mechanism without Housing, from 03.09 ] Selector Mechanism without Housing, from 03.09.

• Checking, refer to => [ Selector Lever Cable, Checking ] Selector Lever Cable, Checking.

• Adjusting, refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

3 Bolt

• 8 Nm.

4 Nut

• 8 Nm.

• Quantity: 4

5 Selector Housing

6 Lock Washer

• Always replace after removing.

7 Lock Washer

• Always replace after removing.