FWD

Shock Absorber and Coil Spring Overview, with Adaptive Chassis DCC






1 Low Spring Plate

• The spring end must sit at the stop.

2 Coil Spring

• There are different suspension versions. Refer to => [ Vehicle Data Label ] Vehicle Data Label.

• Removing and installing, refer to => [ Coil Spring ] Coil Spring.

3 Upper Spring Plate

4 Bracket

• For the rear body acceleration sensor.

• Removing and installing, refer to => [ Rear Body Acceleration Sensor G343 ] Rear Body Acceleration Sensor G343.

5 Rear Body Acceleration Sensor (G343)

• Removing and installing, refer to => [ Rear Body Acceleration Sensor G343 ] Rear Body Acceleration Sensor G343.

• Note the installed position of the bracket - item 4 -.

6 Bolt

• 5 Nm

• Always replace if removed.

7 Bolt

• M14 x 1.5 x 85

• 180 Nm

• Always replace if removed.

8 Bolt

• M10 x 35

• 50 Nm + an additional 90° (1/4) turn.

• Always replace if removed.

9 Shock Absorber with Left and Right Rear Dampening Adjustment Valves (N338/N339)

• Removing and installing, refer to => [ Shock Absorber, with Adaptive Chassis DCC ] Shock Absorber, with Adaptive Chassis DCC.

• There are different suspension versions, refer to => [ Vehicle Data Label ] Vehicle Data Label.

10 Washer

11 Lower Track Control Arm

• Removing and installing, refer to => [ Lower Track Control Arm ] Lower Track Control Arm.

12 Wheel Bearing Housing

• Removing and installing, refer to => [ Wheel Bearing Housing ] Wheel Bearing Housing.

Installed Position: Rear Body Acceleration Sensor to Bracket





The tab on the bracket - 1 - must fit into the recess in the rear body acceleration sensor - arrow -.