FWD

Rear Level Control System Sensor Overview, with Adaptive Chassis DCC

• The vehicle level control system sensor is available as a replacement part, complete with the coupling rod and upper and lower retaining plates.

• Replace with the subframe installed.






1 Subframe

2 Bolt

• M5 x 20

• 5 Nm

3 Left Rear Level Control System Sensor (G76)

• Complete with all components.

• The lever must point toward the vehicle exterior.

• Removing and installing, refer to => [ Left Rear Level Control System Sensor, with Adaptive Chassis DCC ] Left Rear Level Control System Sensor, with Adaptive Chassis DCC.

• If the left rear level control system sensor was removed and then installed, then a basic setting to the adaptive chassis DCC must be performed. Refer to => [ Adaptive Chassis DCC, Basic Setting ] Testing and Inspection.

• If a basic setting was performed on the adaptive chassis DCC on a vehicles with lane assist, then the directional stabilization assistance control module must be re-calibrated. Refer to => [ Lane Assist, Calibrating ] Lane Assist, Calibrating.

• After replacing, perform a basic setting on the headlamps.

Headlamp basic setting, refer to the vehicle diagnostic tester.

4 Lower Track Control Arm