Front Level Control System Sensor Overview, with Adaptive Chassis DCC

Front Level Control System Sensor Overview, with Adaptive Chassis DCC

• A replacement front level control system sensor comes complete with the coupling rod and the upper and lower retaining plates.

• Replace with the subframe installed.






1 Subframe

2 Bolt

• M6 x 16

• 9 Nm

3 Left Front Level Control System Sensor (G78) or Right Front Level Control Sensor (G289)

• Complete with all components,

• The lever must point toward the vehicle exterior.

• Removing and installing, refer to => [ Front Level Control System Sensors G78/G289, with Adaptive Chassis DCC ] Front Level Control System Sensors G78/G289, with Adaptive Chassis DCC.

• If the left and/or right front level control system sensor were removed and installed, then a basic setting to the adaptive chassis DCC must be performed. Refer to => [ Adaptive Chassis DCC, Basic Setting ] Testing and Inspection.

• If a basic setting was performed on the adaptive chassis DCC on a vehicles with lane assist, then the directional stabilization assistance control module must be re-calibrated. Refer to => [ Lane Assist, Calibrating ] Lane Assist, Calibrating.

• After replacing, perform a basic setting on the headlamps.

Headlamp basic setting, refer to the vehicle diagnostic tester.

4 Control Arm

5 Nut

• 9 Nm

• Self-locking

• Always replace if removed.