Left Rear Level Control System Sensor G76, with Adaptive Chassis DCC

Left Rear Level Control System Sensor G76, with Adaptive Chassis DCC

Special tools, testers and auxiliary items required

• Torque Wrench (5-50 Nm) (V.A.G 1331)

Removing

- Disconnect the connector.






- Remove the bolts.

- Remove the left rear level control system sensor.

Installing

Install in the reverse order of removal. Note the following:

The left rear level control system sensor lever must point toward the vehicle exterior.

- Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] Testing and Inspection.

- If the vehicle is equipped with lane assist, then the directional stabilization assistance control module must be calibrated after performing the basic setting on the adaptive chassis DCC. Refer to => [ Lane Assist, Calibrating ] Lane Assist, Calibrating.

- Perform a headlamp basic setting. Refer to the vehicle diagnostic tester.

Tightening Specifications