Steering Column Combination Switch (E595), from 10.09

Steering Column Combination Switch (E595), from 10.09

Removing and installing the steering column combination switch

Depending on equipment, the Steering Column Combination Switch (E595) consists of the following components and cannot be disassembled:

• Turn Signal Switch (E2)

• Windshield Wiper Switch (E)

• Cruise Control Switch (E45)

The procedure for removing and installing the steering column combination switch differs depending on the manufacturer.

• Steering Column Combination Switch (E595).

• Steering Column Combination Switch (E595).

Manufactured by Valeo

Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module, from 10.09 ] Steering Column Switch Module, from 10.09.

Removing

- Remove the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronics control module. Refer to => [ Steering Column Electronics Control Module J527, from 10.09 ] Steering Column Electronics Control Module J527, from 10.09.






- Unlock both releases - arrows - and remove the entire steering column combination switch from the steering column switch base carrier.

Installing

- Push the steering column combination switch onto the guide on the steering column switch base carrier until it latches.

- Install all components in reverse order of removal.

Manufactured by Kostal

Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module, from 10.09 ] Steering Column Switch Module, from 10.09.

Removing

- Remove the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronics control module. Refer to => [ Steering Column Electronics Control Module J527, from 10.09 ] Steering Column Electronics Control Module J527, from 10.09.






- Remove the bolt - arrow - and remove the entire steering column combination switch - 1 - from the steering column switch base carrier.

Installing

- Slide the steering column combination switch onto the guides on the steering column switch base carrier.

- Install the bolt - arrow -.

- Install all components in reverse order of removal.