Fuel Level Sensor 2 G169

Fuel Level Sensor 2 G169

Special tools, testers and auxiliary items required

• Welding wire (2 mm material strength)

- Bend an 80 mm long welding wire as shown.






Dimension - a -: 10 mm

Dimension - b -: 70 mm

Removing

- Remove the suction jet pump. Refer to => [ Suction Jet Pump, Fuel Filter and Pressure Relief Valve ] Suction Jet Pump, Fuel Filter and Pressure Relief Valve.

- Disconnect the connector for the 2 (- 2 -).

- Press the welding wire - 1 - in the - direction of the arrow - into the opening under the sensor.






- At the same time, slide the fuel level sensor 2 (- 2 -) in the - direction of the arrow - from the guides.

Installing

- Install fuel level sensor 2 into the guides and push it down until it latches.

- Connect the connector and check for secure locking.

- Install the suction jet pump. Refer to => [ Suction Jet Pump, Fuel Filter and Pressure Relief Valve ] Suction Jet Pump, Fuel Filter and Pressure Relief Valve.