Passive Occupant Detection System Components, Power Seats

Passive Occupant Detection System Components, Power Seats

Removing

Observe safety precautions when working on seat occupied recognition. Refer to => [ Passenger Occupant Detection System Safety Precautions ] Passenger Occupant Detection System Safety Precautions.

• The seat cushion, mat for passenger occupant detection system, control module and pressure sensor can only be replaced as a single unit. These components are adapted to work together and are not allowed to be separated.

• Only disconnect wiring harnesses mentioned in the following description!

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Perform the following seat adjustment:

• Seat height: highest position

• Seat tilt: highest position

- Remove the front seat. Refer to => [ Front Seat ] Front Seat

- Secure the seat to the fixture for seat repair (VAS 6136).

- Remove the front seat belt latch. Refer to => [ Front Seat Belt Latches ] Front Seat Belt Latches

- Remove seat cap. Refer to => [ Cover Cap ] Cover Cap

- Remove electric seat front end trim. Refer to => [ Power Seat Front Side Trim ] Power Seat Front Side Trim

- Remove electric seat trim. Refer to => [ Power Seat Trim ] Power Seat Trim

- Remove electric seat trim bracket. Refer to => [ Power Seat Trim Bracket ] Power Seat Trim Bracket

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Left Front Seat Backrest

- Remove the cover from the seat area. Refer to => [ Front Seat Cushion Cover and Upholstery ] Front Seat Cushion Cover and Upholstery

- Remove the screw - 1 - and then move the control module with bracket - 2 - and the wiring harness - 3 - to the side.






- Disconnect the connector from the passenger occupant detection system control module (J706).

- Unclip the passenger occupant detection system pressure sensor (G452) from the bracket.

- Disconnect the connector from the passenger occupant detection system pressure sensor (G452).

- Unclip pressure hose - 2 - from retainers.

- Remove the screws - 1 - (1.5 Nm) and the passenger occupant detection system control module (J706) - 3 -.






- Lift the seat cushion - 1 -. When doing this do not separate the seat cushion from the passenger occupant detection system mat - 4 -.

- Remove the clips - 2 - from the lower seat frame - 5 -. Do not remove clip - 3 -.

• The seat cushion, the mat for the passenger occupant detection system, the pressure hose, the passenger occupant detection system pressure sensor (G452) and the passenger occupant detection system control module (J706) are calibrated to work together and may not be replaced by other components.

- Remove the seat cushion and the mat for the passenger occupant detection system from the lower seat frame.

- Guide the pressure hose and the passenger occupant detection system pressure sensor (G452) through the opening inside the seat frame.