Electro-Mechanical Parking Brake Button E538

Electro-Mechanical Parking Brake Button E538

Special tools, testers and auxiliary items required

• Removal Wedge (VAS 3409)

The following components are integrated in the Electro-Mechanical Parking Brake Button:

• Electro-mechanical Parking Brake Indicator Lamp (K213)

• -AUTO HOLD- Indicator Lamp 2 (K238)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (3409) , screwdriver) will be positioned, using commercially available adhesive tape.

Removing

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Remove side cover - 1 - of instrument panel, do this by inserting (3409) or a screwdriver into recess - 2 - and pry off cover - 1 - in - direction of arrow -.






- Push Electro-Mechanical Parking Brake Button - 1 - out of instrument panel from rear.






- Disengage harness connector - arrow - and disconnect harness connector.






Installing

Install in reverse order of removal.