Solar Sensor: Service and Repair

Sunlight Photo Sensor G107 or Sunlight Photo Sensor 2 G134

Special tools, testers and auxiliary items required

• Removal Wedge (3409)

Removing

- Mark dimensions "a and b" on the instrument panel with tape.






a = 115 mm

b = 15 mm

The indirect ventilation trim could get damaged.

The trim is mounted by a screw under the photo sensor.

Lift the trim maximum 15 mm.

- Using the (3409) unclip the right and left trim at the markings and remove them from the instrument panel.

- Insert a screwdriver - 3 - with a long blade toward the photosensor - 2 -.






- Use a block of wood - 1 - underneath.

- Push the screwdriver - in direction of arrow - and unclip the photosensor.

- Disconnect the connector from the sunlight photo sensor.

Installing

- Connect the connector to the photosensor and then install the photosensor in the instrument panel.

- Perform remaining installation operations in reverse order of removal.