Oil Pressure Sender: Service and Repair

Oil Filter/Oil Cooler and Oil Pressure Switch Overview






1 Accessory Bracket

• Removing and installing, refer to => [ Accessory Bracket ] Service and Repair.

2 Oil Pressure Switch (F1)

• 20 Nm

• 1.4 bar - black.

• Checking, refer to => [ Oil Pressure and Oil Pressure Switch, Checking ] Testing and Inspection.

• Removing using the socket 24 mm and jointed extension (T40175).

3 Gasket

• Always replace.

4 O-ring

• Always replace.

5 O-ring

• Always replace.

6 Valve Unit

7 Oil Filter Element

• 22 Nm

• Remove and install using the oil filter wrench (3417).

8 Bolt

• 15 Nm

9 Connection

10 Seal

• Always replace.

11 Engine Oil Cooler

• See the note in the => [ Oil Pan/Oil Pump Overview ] Oil Pan/Oil Pump Overview.

• Make sure there is enough space to the surrounding components.

• Coolant hose connection diagram. Refer to => [ Coolant Hose Connection Diagram ] [1][2]Cooling System.

• Removing and installing, refer to => [ Engine Oil Cooler ] Engine Oil Cooler.

12 Gasket

• Always replace.

13 Bolt

• Tightening sequence, refer to => [ Accessory Bracket Bolt Tightening Sequence ] Ribbed Belt Drive Overview.