Sun Shade, Sedan

Sun Shade, Sedan

Removing

• Removal of sun protection shade is performed when it is in a rolled in state.

- Remove trim on C-pillars, sedan:

• Vehicles without sun shade: => [ C-Pillar Trim Panel, Vehicles without Sun Shade, Passat from MY 2006 ] C-Pillar Trim Panel, Vehicles without Sun Shade, Passat from MY 2006

• Vehicles with sun shade: => [ C-Pillar Trim Panel, Vehicles with Sun Shade, Passat from MY 2006 ] C-Pillar Trim Panel, Vehicles with Sun Shade, Passat from MY 2006

- Remove the seat bench. Refer to => [ Seat Bench, Passat from MY 2006, Passat CC from MY 2009 and CC from MY 2010 ] Seat Bench, Passat from MY 2006, Passat CC from MY 2009 and CC from MY 2010

- Remove side upholstery:

• With rear side airbag: => [ Side Upholstery with Side Airbag ] Side Upholstery with Side Airbag

• without rear side airbags: => [ Side Upholstery without Side Airbag ] Side Upholstery without Side Airbag

- Remove rear shelf (vehicles with sun shade). Refer to => [ Rear Shelf with Sun Shade ] Rear Shelf with Sun Shade

• Removal is described for the left side of the vehicle, removal on the right side is the same.

- Remove trim - 1 - from mounts in sun shade guide - 2 -.

- Remove bolt - 3 - (1.5 Nm).

- Remove sun shade guide - 2 - from mounts in body.

- Loosen sun shade guide - 2 - from mounts in sun shade - 4 -.






- Remove two screws - 1 - (1.5 Nm) on each holder.

- Remove sun shade - 2 - upward out of mounts.

- On vehicles with electric sun shade, disconnect wiring harness.






Installation

- To install, perform the steps used for removal in reverse order.

• Before installation, mounting elements of rear shelf must be checked for damage and replaced if necessary.