Right Luggage Compartment Side Trim, Passat Wagon from MY 2006
Right Luggage Compartment Side Trim, Passat Wagon from MY 2006
Removing
- Switch off the ignition.
Vehicles with rear side-airbag:
- Disconnect the battery.
All vehicles:
- Remove the lock carrier cover, Passat Wagon from MY 2006, refer to => [ Lock Carrier Cover, Passat Wagon from MY 2006 ] Lock Carrier Cover, Passat Wagon from MY 2006
- Fold the right bench seat and its backrest forward.
- Remove the side cushion:
• With rear side airbag, refer to => [ Side Upholstery with Side Airbag ] Side Upholstery with Side Airbag
• without rear side airbags => [ Side Upholstery without Side Airbag ] Side Upholstery without Side Airbag
- Pull wheel housing trim - 1 - in upper area out of mounts in body.
• For the sake of illustration, wheel housing trim - 1 - and clip - 2 - are depicted as removed.
• Illustration shows left side of vehicle, disengaging wheel housing trim on left side of vehicle is performed accordingly.
Vehicles without track system:
- Remove two bolts - 1 - (6 Nm) and remove tie down - 2 -.
- Remove two bolts - 3 - (6 Nm) and remove tie down - 4 -.
All vehicles:
- Remove bolt - 5 - (4.5 Nm) and remove coat hook bracket - 6 -.
- Remove the clamping pin - 7 - using a screwdriver with hex socket head (3 mm) and remove expanding rivet - 8 -.
- Pull trim - 9 - inward out of retainers in body.
- Thread seat belt - 10 - through both tabs - 11 - of trim - 9 -.
- Slide trim away toward front over bracket for backrest lock - 12 -.
- Disconnect wiring harness of luggage compartment light.
- Remove trim from vehicle.
Installing
- Install in reverse order of removal.
• Before installing, check metal clips for damage and replace if necessary.