Lock Cylinder Housing

Lock Cylinder Housing

• Removing and installing the lock cylinder housing is described. Removing and installing the left lock cylinder is identical.

Removing






• Cover cap for lock cylinder housing has been removed. Refer to => [ Cap ] Cap

- Remove the cap - 4 - in front of the bolt - 5 -.

- Pull out the door handle - 2 - until it stops and remove the bolt - 5 - until the lock cylinder housing - 1 - is able to be removed.

- Remove the lock cylinder housing - 1 - from the door handle mounting bracket - 3 -while at a right angle to the door.

• Door handle remains standing in pulled-out position. Do not attempt to press door handle in, otherwise the retaining tab on the mounting bracket breaks off and a removed door handle can no longer be installed.

Installing






In the pulled-out position, door handle - 2 - must stick out from the door.

- Insert the lock cylinder housing - 1 - into the mounting bracket - 3 - at a right angle.

- Install the bolt - 5 - into the bracket.

Door handle - 2 - swings automatically on to door.

• The lock cylinder housing must be pressed onto the outer door panel while installing.

Install in reverse order of removal.

• Always perform a functionality test with the door open.