Left Flange Shaft and Seal

Left Flange Shaft and Seal

Special tools, testers and auxiliary items required

• Slide Hammer-Complete Set (VW 771)

• Thrust Piece (T10160)

• Torque Wrench (5-50 Nm) (V.A.G 1331)

• Drip Tray

Removing

- Remove the left front wheel.

- Remove the noise insulation.

- Remove the left wheel housing liner..

- Turn the steering wheel to the left.

- Remove the left drive axle from the flange shaft.

- Tie the drive axle as high up as possible. Be careful not to damage the paint on the drive axle.

- Place the used oil collecting and extracting device or drip tray (V.A.G 1782) under the transmission.

- Remove the bolt for the flange shaft, by installing two bolts into the flange and counter holding the flange shaft using a pry bar.






- Remove the flange shaft and the pressure spring.

- Remove the flange shaft seal using the slide hammer-complete set (VW 771) and additional part for VW 771 (VW 771/37).






Installing






- Lightly coat the outer circumference of the new seal with oil.

- Fill the area between the sealing and dust lips - arrow - halfway with sealing grease for seal (G 052 128 A1).

- Drive in the new seal until seated and without tilting it using the thrust piece (T10160).






- Install the flange shaft.

- Push the flange shaft against the pressure spring on the transmission housing and tighten the bolt to specification, see - item 10 - in => [ Differential Overview ] Description and Operation.

- Install the drive axle to the flange shaft.

- Check the transmission fluid level. Refer to => [ Transmission Fluid, Checking and Filling ] Service and Repair.

- Install the left front wheel housing liner..

- Install the noise insulation.

- Install the wheel.