Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Depth gauge

Note the following whenever working inside the engine compartment due to limited space:

• Route all lines and wires in their original locations.

• Ensure sufficient clearance to all moving or hot components.






Removing

- Remove the transmission.

- Lock the crankshaft, refer to => [ Crankshaft, Locking ] Procedures and remove the drive plate bolt and plate.

Installing

- Install the drive plate with only the washer - 1 -.






- Install new bolts - 3 - and tighten them to 30 Nm.

- Check the dimension - a - at three points and calculate the mean value.






Specified value: 18.8 to 20.4 mm

• Measure through the drive plate hole to the control housing cover surface.

If the specification is not obtained:

- Remove the drive plate and install the shim - 2 -, drive plate and the washer - 1 -. Reinstall the bolts - 3 - and tighten them to 30 Nm again, then repeat the measurement.






If the specification is obtained:

- Tighten the bolts to 60 Nm + an additional 90° (1/4) turn, the additional turn can occur in several stages.

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the locking pin (T40069) from the cylinder block and install the plug (30 Nm).