Wiring Harness, with 8 Pin Connector

Wiring Harness, with 8 Pin Connector

Removing

- Drain the transmission fluid. Refer to => [ Transmission Fluid, Draining and Filling ] Transmission Fluid, Draining and Filling.

- Remove the valve body. Refer to => [ Valve Body ] Service and Repair.

- Disconnect the sensor connector - 1 - from the transmission connector.






- Remove the bolt from the 8 pin transmission connector.

- Remove the connector and the wiring harness from the transmission housing.

Installing

Installation is performed in the reverse order of removal while observing the following:

- Replace the O-ring on the connector.

- Push the connector all the way into the transmission.

- Tighten the bolt for the 8 pin transmission connector. For the correct tightening specification, refer to => [ Fastener Tightening Specifications ] Fastener Tightening Specifications - Gears, Hydraulic Controls.

- Install the valve body. Refer to => [ Valve Body ] Service and Repair.

- Fill the transmission fluid and check the level. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.