Selector Shaft Seal

Selector Shaft Seal

Special tools, testers and auxiliary items required

• Thrust Piece (T10174)

• Pulling Hook (T20143)

Removing

- Remove the multifunction transmission range switch. Refer to => [ Multifunction Transmission Range Switch (F125) ] Service and Repair.

- Remove the selector shaft seal carefully using a screwdriver or the pulling hook (T20143). Be careful not to damage the selector shaft when doing this.

Installing

- Coat the outer circumference and sealing lips of the seal with transmission fluid.

• Installed position: The open side of the seal faces the transmission housing.

- Install the new shaft seal until seated, using the thrust piece (T10174). Do not tilt the seal when doing so.






- Install and adjust the multifunction transmission range switch. Refer to => [ Multifunction Transmission Range Switch (F125), Adjusting ] Adjustments.