Transmission Fluid, Draining and Filling

Transmission Fluid, Draining and Filling

Special tools, testers and auxiliary items required

• Used Oil Collecting and Extracting Device (V.A.G 1782)

• Drip Tray for VAS 6100 (VAS 6208)

• Adapter for Oil Filling (VAS 6262 A)

• Adapter for Filling ATF Oil (VAS 6262/2)

- Turn off the engine.

• Place the drip tray for VAS 6100 or used oil collecting and extracting device (V.A.G 1782) under the transmission.

- Remove the plug from the transmission pan - arrow -.






- Remove the overflow tube - 1 - from the plug hole.






- Drain the transmission fluid.

- Reinstall the overflow tube.

- Install the adapter for oil filling (VAS 6262 A) to the fluid bottle. Be sure to read the instructions => [ Note the Following Information: ] Transmission Fluid Level, Checking and Filling.

- Install the adapter for filling ATF oil (VAS 6262/2) into the plug hole hand tight.






- Fill with 3 liters of fluid. Refer to the Parts Catalog.

- Remove the adapter for filling ATF oil (VAS 6262/2) from the pan and reinstall and tighten the plug with the old seal.

- Move the selector lever into the "P" position.

- Start the engine.

- With the brake pedal pressed, move the selector lever through all the different positions "P, R, N, D, S" at idle, stopping at each position for at least 10 seconds.

- Move the selector lever into the "P" position.

- Check the ATF level and add, as necessary. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.