Ribbed Belt Pulley, Denso A/C Compressor Overview

Ribbed Belt Pulley, Denso A/C Compressor Overview

• Different versions of the ribbed belt pulley may be installed, depending on A/C compressor construction type and engine version. Refer to Electronic Parts Catalog (ETKA).

• Ribbed belt pulley, removing and installing, refer to => [ Ribbed Belt Pulley, Denso A/C Compressor ] Ribbed Belt Pulley, Denso A/C Compressor.






1 Cap

2 Cover With Locking Ring

• Remove carefully using a small screwdriver or needle-nose pliers (pay special attention to ribbed belt pulley when doing this)

3 Drive Plate

• Remove with the pin wrench (3212).

4 Circlip

• Always replace

• Install on correct side (flat side toward A/C compressor).

5 Spacer

6 Ribbed Belt Pulley

• The ribbed belt pulley is made of plastics and is sensitive to impact, be especially careful when handling it.

• Different versions. Refer to Electronic Parts Catalog (ETKA).

7 A/C Compressor

• Depending on engine and market version, different versions can be installed. Refer to Electronic Parts Catalog (ETKA).

• Clean A/C compressor flange before sliding on ribbed belt pulley.

8 Rubber Element

• Quantity: 6

• Decouples the ribbed belt pulley from the A/C compressor input shaft and dampens vibration and noise.

• For installation, lightly coat rubber elements, for example, with tire mounting paste or a soap solution (as a lubricant).