Engine and Transmission Mount Adjustment, Checking

Engine and Transmission Mount Adjustment, Checking

• There must be at least 10 to 13 mm - a - between the engine mount bracket - 2 - and right longitudinal member.






• The casting edge on the engine mount bracket - 2 - must be parallel to the engine mount support arm - 1 -; dimension - x - must be the same at the front and at the rear.

• Distance - a - can also be checked with corresponding round stock.

Only if there is a noise (the engine or transmission hitting the longitudinal member when driving around curves) and dimension - a - is not within 10 to 13 mm:

- Adjust the engine and transmission mount. Refer to => [ Engine and Transmission Mount, Adjusting ] Engine and Transmission Mount, Adjusting.